Are the drive gears the same? 392, 345?

[possum scout]

I'm going to put the ford dura-spark in, but need the Holley for easier conversion. (p-lite requires machining)

Did IH only use presto-lite and the Holley? Those are the only 2 I know of.

Are the drive gears the same for these 2 motors? (345 and 392)
Can the gears be swapped between the 2 distributors?

There are a couple IH trucks in my local "bone-yard".

[Bill usn-1]

Re: Are the drive gears the same? 392, 345?

Originally posted by possum scout
I'm going to put the ford dura-spark in, but need the Holley for easier conversion. (p-lite requires machining)

Did IH only use presto-lite and the Holley? Those are the only 2 I know of.

Are the drive gears the same for these 2 motors? (345 and 392)
Can the gears be swapped between the 2 distributors?

There are a couple IH trucks in my local "bone-yard".

As far as I seen there is a Holley point, holley GB, and prestolite for the ScoutII V-8s.
The prestolite and holley drive gears I have are the same.
BUT I have seen IH drill the holes different on dist. So just because the gear will fit fine, the roll-pin hole may not line up exactly right. take a close look at them before you swap. The hole may be off-set to one side a little.

HTH